Samsung NC10 User Manual page 104

Using the network after moving
location
By setting the network settings (IP
address, printer setting, etc.) for each
location, you can immediately access the
network without performing the network
setting procedures regardless of your
location.
Run Samsung Network Manager
1
when connected to the Internet.
2
Select an icon that represents the
corresponding location from the
Saved Locations window and then
click Move.
When the network settings of the
3
selected location are applied, the new
location and the network connection
information are displayed in The
detailed Information for window.
Sharing Internet Access
Set one computer as the sharing server
and another computer as the client for
two computers to share an Internet using
one Internet line. Once the configuration
is complete, you can use the Internet
immediately.
If you perform Internet sharing
setup by using Samsung Network
Manager, the program must be
installed into both computers.
There are three methods for setting each
computer as a sharing server and a client
as shown in the table. This document
describes how to do so by giving an
example to the typical connection method
1 (Wire+Wireless).
Sharing Server (Hereinafter
referred to as server)
Computer that is equipped with two
LANS and is directly connected to an
Internet.
Sharing Client (Hereinafter
referred to as client)
Computer that is not directly
connected to the Internet and is
able to use the Internet through the
sharing server.
10