Toshiba D-R265SE Service Manual page 28

Message
This disc is protected and not
recordable.
Disc is full.
(No area for new recording)
You cannot record more than
99 titles on one disc.
(The maximum is 99.)
You cannot record more than
999 chapters on one disc.
(The maximum is 999.)
You cannot record on this disc
as Control Information is full.
You cannot record on the disc
as Power Calibration Area is
full.
This disc is already finalized.
Can not record on this disc.
If an error occurs during the timer recording, one of the following error numbers (40 to 42) or the above error
messages (error number: 1 to 39) is displayed on the recording menu after timer recording.
(Once the screen of the program line is exited, the program line for the error will be cleared.)
(No Error Message is displayed for the error No. 40 ~ 42.)
A program with the error number is grayed out and asterisked on the timer programming list.
Message
Error message is not
displayed.
Solution
Release the disc protect
setting in the Disc Setting
menu.
Insert the recordable disc with
enough recording space.
Delete unnecessary titles.
Delete unnecessary chapter
markers.
Delete unnecessary titles.
Insert a new disc.
Release the finalizing for this
disc.
Repeat the same operation.
Timer Progra mming
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
Solution
- Set the timer programming
correctly.
- Set the timer programming
before the start time.
Turn the power on and set the
clock correctly then set timer
programming again.
Insert the recordable disc.
Error
Error Description
No.
29 Disc Protected Disc.
30 No avilable recording space.
Its recording capacity has been reached.
31
(Video Format Disc)
Its recording capacity has been reached.
32
(VR Format Disc)
The 999 chapter has been reached. (VR
33
Format Disc)
There is not space to record field of
34
control information.
35 PCA is Full. (in REC start)
36 It is finalized. (Video Format Disc)
37 Access to Memory Area range outside.
38 Sector Address is wrong.
39 BUP writing error of chapter editing.
Mode
The speed mode changes
to the error number.
Error
Error Description
No.
- Some portion has not been recorded
because of program overlapping.
40
- Recording did not start at the start time.
41 Power failed
42 No disc when recording
1-9-2
Priority
7
5
7
8
9
10
4
6
-
-
-
Priority
-
-
-
E7A70FIS