Installation And Connection; Product Package; Safety Instructions; Delivery - Siemens SK Series Operating Instruction

en

Installation and connection

Installation and
connection
l a t i o n I n s t a l
The dishwasher must be connected
correctly, otherwise it will not function
properly. The specifications for the inlet
and outlet as well as the electrical
connected loads must correspond with
the required criteria as
specified in the following paragraphs
or in the installation instructions.
Install the appliance in the correct
sequence:
1. Checking appliance on delivery
2. Installing the appliance
3. Waste water connection
4. Drinking water connection
5. Electrical connection

Product package

If you have any complaints, contact
the dealer where you purchased
the appliance or our customer service.
Dishwasher
Instructions for use
Installation instructions
Warranty*
Installation materials
Steam guard plate*
Power cord
* depending on model

Safety instructions

Please follow the safety instructions
under "Installation".
32
a n d

Delivery

Your dishwasher has been checked
thoroughly in the factory to ensure that it
o n c o n n e c t i
is in working order. This may cause
small water stains. These will disappear
after the first wash cycle.

Technical specifications

Weight:
max. 24 kg
Voltage:
220–240 V, 50 Hz or 60 Hz
Connected load:
2.0–2.4 kW
Fuse:
10/16 A (UK 13A)
Power input:
off mode (Po)* 0.10 W
left on mode (Pl)* 0.10 W
*according to regulations (EU) nos.
1016/2010 and 1059/2010
Additional functions and settings may
increase the power input.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
max. temperature 25 °C