Fault Table - Siemens SK Series Operating Instruction

en Fault, what to do?

Fault table

Fault
"Check water supply"
display ` lights up.
Fault code : is lit.
Fault code : is lit.
Fault code : is lit.
Error code : is lit.
Error code : is lit.
Error code : is lit.
Error code : is lit.
24
Cause
Supply hose kinked.
Tap turned off.
Tap jammed or calcified.
Filter in the water supply blocked. Switch off the appliance and pull out
Water protection system
activated.
Constant water inflow.
Filters 1* are soiled
or blocked.
Waste water hose
is blocked or kinked.
Siphon connection still sealed.
Cover on the waste water pump
loose.
Waste water pump blocked
or cover on the waste water
pump is not locked in position.
Mains voltage too low.
Remedial action
Install supply hose without kinks.
Turn on the tap.
Turn on the tap.
Flow rate must be min. 10 l/min.
when water supply is open.
the mains plug. Turn off the tap. Unscrew
water connection.
Clean filter in the supply hose. Screw water
connection on again. Check for leaks.
Reconnect power supply. Switch on
the appliance.
Turn off tap.
Call customer service and mention the fault
code.
Clean filters.
(See Cleaning and maintenance)
Install hose without kinks, remove any
residue.
Check connection to siphon and open
if required.
Lock cover correctly.
(See Waste water pump)
Clean pump and lock cover correctly. (See
Waste water pump)
Not an appliance fault, have the mains
voltage and electrical installation checked.