Led Display Anode And Service; Customer Service - Siemens DG15025 Assembly And Operating Instructions Manual

LED display anode and service

In normal operations, the LED "anode" is constantly lit, the LED "service" is off.
If one of the two LEDs flashes, this indicates an "error condition".
To begin with, please reset the device ➜ RESET. To do this, proceed as follows:
•
Firstly turn the dial to the setting " ".
After that, press the "fast-heating" button .
If the cause of the error condition does not exist directly after the reset, the device will again return to its normal mode of func-
tion. Otherwise the device will again indicate an "error condition".
In this case please contact the customer service operator.
Cleaning
• Wipe with a damp cloth. Do not use any sharp or coarse cleaning products.
• Do not use a steam cleaner.

Customer Service

In order to avoid hazards, repairs may only be carried out by a customer service operator licensed by us.
The initial service through our customer service operator should take place around two years after the first operation. At this
time, the device will potentially be decalcified. Afterwards, the customer service operator will recommended a date for the next
service. Specify the E-No. and FD-No. when phoning the customer service operator!
When requesting customer service, please enter the E-No. and the FD-No. of your device.
You will find the numbers on identification plate between the water access pipes of the reservoir.
Siemens-Electrogeräte GmbH
E-Nr. FD
Disposal
This appliance is labelled in accordance with European Directive 2012/19/EU concerning used electrical and electronic appli-
ances (waste electrical and electronic equipment - WEEE). The guideline determines the framework for the return and recycling
of used appliances as applicable throughout the EU.
Please ask your specialist retaller about current disposal facilities.
Subject to change.
22