3 3 3 3 Setting The Timer; 3 3 3 3 Care And Maintenance; Cleaning The Air Filter; Cleaning The Front Panel - Panasonic CU-SA12CKP Operating Instructions Manual

Setting the Vertical Airflow Direction
Press AIR SWING button to select.
The adjustment angles of the airflow direction
louvers for Heating, Cooling and Soft Dry
operations are different.
Cooling/Soft Dry
approx. 36˚
* 5 adjustment
Heating
approx. 55˚
Ensure that the angles of the vertical airflow
direction louvers are adjusted by using the remote
control. If it were manually adjusted, the proper
mechanism of the louvers may be affected. If such
a case, turn off the air conditioner temporarily and
then restart the operation.
During Cooling and Soft Dry operations, please
avoid the vertical airflow direction louvers from
positioning in a downward direction for a long
period. Otherwise, if condensation occured near
the airflow direction louver and air outlet vents, it
may result in water dripping.
To adjust the horizontal airflow direction, manually
move the Horizontal Airflow Direction Louver.
To move the Vertical Air Flow
Direction Louver by hand.
After the air conditioner stopped and restarted
immediately, the compressor will not operate within
3 minutes. (For compressor protection purposes.)
5
F563553/01-08/EN 6
SETTING THE TIMER
CANCEL
ON-TIMER Operation
To start the air conditioner operation automatically.
Press ON to set the operation.
Closed
Press ON to increase or decrease the time.
Then press SET .
To cancel this operation, press CANCEL .
angles available.
OFF-TIMER Operation
To stop the air conditioner operation automatically.
Press OFF to set the operation.
Press OFF to increase or decrease the time.
Then press SET .
To cancel this operation, press CANCEL .
The OFF-TIMER can only be set while the
air-conditioner is in operation.
Timer Mode Operation Details
The ON-TIMER and OFF-TIMER cannot be set
simultaneously.
The set time that appears on the remote control
display is actually the remaining set time which will
appear after every hour of operation.
If you press operation OFF/ON button during the
timer setting operation, timer setting will be
cancelled. (The timer indicator of the Indoor Unit
will go off.)
When the ON-Timer is set, operation will start
before the actual set time. This is to enable room
temperature reaches the set temperature at the set
time.
COOL – 15 minutes in advance
HEAT, AUTO – 30 minutes in advance
CARE AND MAINTENANCE
MODE
OFF ON FAN SPEED
TIMER
AIR SWING
SET
RESET
5/6/02, 10:34 am
Cleaning the Indoor Unit and Remote Control
Wipe gently with a piece of soft, dry cloth.
Do not use water hotter than 40˚C or polishing fluid to
clean the unit.

Cleaning the Air Filter

(Recommendation:- If the unit is operated in a dusty
environment, clean the filters every two weeks,
continuous use of this dirty filters will reduce cooling or
heating efficiency)
1 Remove dirt using a vacuum cleaner.
2
Wash back of the air filter with water.
3
If badly soiled, wash it with soap or a mild household
detergent.
4 Let it dry and reinstall it.
* Be sure the "FRONT" mark is facing you.
Damaged air filter.
Consult the nearest authorized dealer.
Part No.: CWD001050.
Do not use benzene, thinner, scouring powder or
cloth soaked in caustic chemical to clean the unit.

Cleaning the Front Panel

(Must be removed before washing)
1
Raise the front panel higher than the horizontal and
pull to remove it.
2 Gently wash with water and a sponge.
Do not press the front panel too hard when washing.
When use kitchen cleaning fluid (neutral
detergent), rinse thoroughly.
Do not dry the front panel under direct sunlight.
3
To fix the front panel, raise the front panel
horizontally, match the protruding portion on the
indoor unit to the fulcrum and push into place.
Fulcrum
Front grille pivot