Setting The Timer - Sanyo SAP-URV246EH Instruction Manual

1. How to set the present
time
2. How to set the OFF time
20

Setting the Timer

In the descriptions below, the following settings are used for the temperature
NOTE
and time indicator selector button on the bottom front section of the remote
control.
• Temperature: °C
• Time: AM, PM
(Example) To set to 10:30 pm.
1. Press the CLOCK button once if
the time indicator is not flashing.
2. Press the Advance, Return ( ,
) button until PM 10:30 is
displayed.
3. Press the CLOCK button again.
(Example) To stop the air conditioner at 11:00 am.
1. Press the OFF TIME setting
button once.
2. Press the Advance, Return ( ,
) button until AM 11:00 is
displayed.
3. Wait a few seconds, and then
the setting is complete.
Operation Indication
The time indication alone flashes.
The time can be set in 1-minute
increments. Holding down the
button advances the time rapidly in
10-minute increments.
This completes the setting of the
current time.
The timer indication is
displayed, and the present OFF
time is shown.
The timer indication blinks.
The time can be set in 10-minute
increments. Holding down the
button advances the time rapidly in
10-minute increments.
The timer indication stops
blinking and the present time is
displayed.