Set Date And Time Display - Samsung OfficeServ 100 System Administration Manual

Samsung OfficeServ 100

SET DATE AND TIME DISPLAY

[MMC 505]
Should it ever become necessary to correct the date and time displayed on all of the keysets, do so
as soon as you notice that they are incorrect. Automatic operating mode will not work correctly and
SMDR reports will be of no value if the date and time are not correct.
The display format is as follows:
W (Day of the week, 0-6): e.g., enter 0 for Sunday and 6 for Saturday.
MM (Month, 01-12): e.g., enter 01 for January and 12 for December.
DD (Day of the month): enter a number in the range 01–31.
YY (Year): enter the last two digits of the year, e.g. 95.
HH (Hours): use the 24-hour clock and enter a number in the range 00–24.
MM (Minutes): enter a number in the range 00–59.
Failure to enter the time using the 24-hour clock will cause the date to change at 12:00 P.M.
Open customer-level programming and follow these instructions.
ACTION
1. Press Transfer (or TRSF) 505
Display shows
2. Enter the new time and date using
the above format
3. Verify the time and date and reenter
them if necessary
4. Press Transfer (or TRSF) to store and exit
programming OR press SPEAKER to store
and advance to the next program
If you enter invalid data, you will receive an [INVALID ENTRY] message for three seconds. Reenter
the correct date and time. If the information you entered is incorrect, repeat the procedure.
12
System Administration Guide
DISPLAY
OLD : 6 0 1 0 1 8 4 : 0 0 4 7
NEW : WMMDDYY : HHMM
OLD : 6 0 1 0 1 8 4 : 0 0 4 7
NEW : 3 0 2 0 9 9 4 : 1 4 4 5