Operating Other Components Using The Remote Control; Setting The Manufacturer Code - Yamaha AV-XS80 Owner's Manual

OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL

Setting the manufacturer code (remote control signal
assigned to each manufacturer) for your TV, VCR or
DVD player on the remote control allows you to operate
not only the AVX-S80 but also your TV, VCR or DVD
player using the remote control.
Note
• Depending on the model, certain components from other
manufacturers cannot be controlled, or only limited functions
can be controlled, even though the proper manufacturer code
has been set. If you encounter this problem, please use the
remote control supplied with the component.

Setting the manufacturer code

Manufacturer codes can be set for TV, VCR and DVD/CD
buttons only.
Note
• TV manufacturer codes can be set for the TV button only.
However, any of the manufacturer codes can be set for the VCR
and DVD/CD buttons.
TV
CODE SET
1
While pressing CODE SET, press the input
selector button (TV, VCR, DVD/CD) for which
the manufacturer code is to be set.
Only one manufacturer code can be set for each input
selector button.
Note
• Keep pressing CODE SET between step 1 and 2.
• Refer to "LIST OF MANUFACTURER'S
CODES" at the end of this manual.
32
E7-S80-32-34(5.8)a
AV
POWER POWER
TV AV SLEEP
TV MODE
INPUT TUNER
CH VOL
VCR
VCR
MUTE
SUBTITLE AUDIO
REC
VIDEO 2
VIDEO 1
CD
DVD/CD
DVD
CODE SET AMP
HALL JAZZ ROCK ENTERTAINMENT
1 2 3 4
Numeric buttons
SPORTS MONO MOVIE MOVIE 1 MOVIE 2
5 6 7 8
/DTS SELECT MATRIX 6.1 STEREO
9 0 10
CANCEL
TOP MENU MENU
LEVEL SET MENU
MUTE
PRESET
ABCDE
CH CH
ENTER
PRESET
TEST B.BOOST
VOL
ON SCREEN RETURN
(U.S.A. model)
32
2
Keeping CODE SET pressed, enter the 1-
digit device code and the 2-digit
manufacturer code for the component to be
controlled using the numeric buttons.
You can release CODE SET after entering the code.
y
• The manufacturer code 99 has been set for the remote control
selector buttons (TV, VCR and DVD/CD) at the factory.
3
Press POWER (TV or AV) and check that the
component to be controlled turns on and off
(standby).
Precautions when performing the setting
You can operate the component using the TV, VCR or
DVD player operation buttons on the remote control once
the manufacturer code is set properly. If unsuccessful,
perform the procedure from step 1 again. Pay attention to
the following points when you perform the procedure.
• Check that the correct remote control selector button
has been selected when setting the manufacturer code.
• If more than one code is given for a manufacturer, try
entering each code in the order given.
• Remove and replace the remote control's batteries
(complete this step within 2 minutes) and then perform
the procedure. While replacing the batteries, be sure not
to press any button on the remote control. Doing so
may erase the manufacturer code which has been set
for other remote control selector buttons.
To reset the manufacturer code to the
factory-set code
Follow steps 1 to 2 for the procedure "Setting the
manufacturer code", and enter the device code for the
component and "99" while pressing CODE SET in step 2.
(It is not necessary to follow step 3.)
02.6.29, 4:34 AM