GE 18 Owner's Manual And Installation Instructions page 5

About the fresh food compartment shelves.
Shelf supports at various levels allow you to custom-space your shelves. Not all features are on all models.
2 Lift up and out
1 Tilt up
Half-Width Shelves
One end of the shelf rests on a molded side-
wall support; a bracket on the other end
hooks into a track on the rear cabinet wall.
To remove, lift the shelf up at front, then off
the support and out of the track.
To replace, select desired shelf height. With
shelf front raised slightly, hook the bracket's
top lug into the track, then lower the shelf
onto the support.
Full-Width Shelves
Some models have a steel wire sliding shelf,
a stationary tempered glass shelf or two steel
wire stationary shelves. These shelves can be
moved to another place in the fresh food
compartment.
The full-width sliding shelf has stop-locks.
When placed correctly on the shelf supports,
the shelf will stop before coming completely
out of the refrigerator and will not tilt when
you place food on it or remove food from it.
To remove the full-width shelves, lift the rear
of the shelf and pull forward.
To remove a full-width shelf when the fresh
food compartment door cannot be opened fully,
lift the rear of the shelf, pull forward and
down, tilt the shelf and take it out.
NOTE: The shelf to the right of the track is designed
to hook into the right-hand slot; the shelf to the left
is designed to hook into the left-hand slot.
5