Technical Data; Your New Appliance; Operating Instructions - Siemens DS40022 Installation And Operating Instructions Manual

Technical data

Design
Capacity
Rated pressure
Weight empty
Class of protection accord. to
Degree of protection accord. to VDE
Mark of conformity
Cold-water connection
Hot-water connection
Circulation connection
Flow rate max.
Rated voltage
Tank material
Energy efficiency class
Hot water heating energy efficiency
Load profile
Annual energy consumption
Daily energy consumption
Sound power level
Mixed water quantities V40 according to
the European Guideline 814/2013
Mixed water quantities at 40 °C (15 °C/65 °C)
according to EN60379

Operating instructions

Please read and observe the detailed safety instructions
at the start of these instructions!
Important: The appliance may never be exposed to frost!
■
Risk of electric shock!
Switch off the mains voltage supply immediately if
a fault occurs.
Immediately shut off the cold water supply to the appli‑
■
ance should it leak.

Your new appliance

This floor‑standing water heater enables you to heat up as
much drinking water as required to approximately 60 °C and
store it for household use.
On request a qualified professional will increase the maxi‑
mum adjustable temperature to approx. 80 °C.
Several tap connections can be supplied with hot‑water. The
mixers can always supply cold‑water.
Our products are environment‑friendly, can be recycled and
conserve energy.
12
en
[l]
[MPa (bar)]
[kg]
VDE
[l/min]
[V~]
[%]
[kWh]
[kWh]
[dB]
[l]
[l]
DS20022 DS30022
sealed (pressurised)
200 300
0.6 (6) 0.6 (6)
55 68
V
D E
G 1/2 A
30 38
230/400 230/400
steel, interior specially enamelled
C C
38.7 38.8
XL XL
4332 4316
19.920 19.828
15 15
317 490
397 590
How to operate
VI.
the floor-standing water heater
Adjustments are facilitated by the control panel on the ap‑
■
pliance. The control panel indicates the various settings,
temperatures, volumes of water and how many baths or
showers may be taken.
Preselect the required temperature with temperature
■
selector switch 1.
Position
• Cold and anti‑freezing protection
I The water is heated to approx. 38 °C.
E Energy conservation position. The water is heated to
approx. 60 °C.
The selector switch will click into place at position "E".
IIl Setting for hot‑water and when large amounts of hot‑
water are required. The water is heated to approx. 80 °C.
(this setting only by qualified professional)
During the heating process, expansion water drips out of
■
the safety valve.
Rotate the temperature selector switch 1 to position "•" to
■
switch off the heating.
DS40022
400
0.6 (6)
85
I
IP X4
DIN
AGI
G 1 A
G 1 A
45
230/400
D
38.6
XXL
5586
25.438
15
617
780