Manual Organization - HP 9000 Installation And Configuration Manual

Manual Organization

This manual contains the following chapters and appendices:
Chapter 1 Overview - presents an overview of the ACC Base
Software, and the features that are supported.
Chapter 2 Software Installation and Verification - describes
how to install the ACC Base Software. It describes how
to verify that the ACC software and hardware have
been installed and are functional, and how to bring up
the ACC subsystem.
Chapter 3 Protocol Configuration - contains an overview of
how to configure protocols into the ACC system. It
describes how to use the ACC Protocol manuals to
create a configuration, and how to coordinate
configuring multiple protocols on a given system. The
creation of configuration files is discussed.
Chapter 4 Dual Interface Configurations - describes the use of
the dual interface configurations, including a
discussion of the watch program.
Appendix A Files, Utilities, and Daemons - lists the
configuration files, device files, and log files that are
used by the ACC Subsystem. It also lists related utility
and daemon programs.
Appendix B Tuning and Sizing - lists ACC software related
parameters that can be modified to reflect the system
requirements.
Appendix C ACC Service Guard Configuration Notes -
provides an example of using zconfig () in the Loopback
mode in a Service Guard clustered environment.
13