Siemens HB36D.70B Instruction Manual page 57

Problem
"Fill water tank" appears, even
though the tank is not yet empty
or
The tank is empty. "Fill water
tank" does not appear
The water tank empties for no
discernible reason. The
evaporator dish overflows
The evaporator dish has boiled
empty even though the tank is p y g
full
"Empty tank / clean?" appears in
the display
There is a "pop" noise during
cooking
The first time you cook with
steam, there is a lot of steam
Steam escapes from the
ventilation slots during cooking
The appliance is not producing
steam properly
The error message "E1" or "E2"
appears in the clock display
The error message "E16" or
"E17" appears in the clock
display
Possible cause
The tank is dirty. The
moving water level
indicators are jammed
The tank was not closed
properly
The seal in the tank is
faulty
The tank lid seal is dirty
The water tank has not
been pushed in properly
The feed line is blocked
The appliance has not
been used for at least 2
days and the water tank is
full
Cold/warm effect of frozen
food, caused by the steam
The appliance is being
automatically calibrated
Limescale has formed in
the appliance
The temperature sensor
has failed
Technical fault
Repairs may only be carried out by fully trained
after sales service technicians. Incorrect repairs
may result in serious injury to the user.
Notes/remedy
Shake and clean the tank. If the parts
can not be released, obtain a new
water tank from the after sales
service.
Close the lid until you feel it engage.
Obtain a new water tank from the
after sales service.
Clean the seal.
Slide the tank in until it engages.
Descale the appliance. Check whether
the water hardness range is set
correctly
Empty and clean the tank.
Always empty the water tank after
cooking.
This is normal.
This is normal.
This is normal.
Start the descaling programme.
Contact the after sales service.
Contact the after sales service.
57