Installing The 7914 Expansion Module - Cisco 7914 Manual

Warning The power supply must be placed indoors.
Only use the specified Cisco-approved power
Caution
supply on this product.
2
Installing the
7914 Expansion Module
To ensure a successful installation of the
Note
7914 Expansion Module, make sure you have read the
entire "Before You Begin" section on page 2.
To install the 7914 Expansion Module, perform the following
steps.
1. Remove the Footstand from the Cisco IP Phone 7960G.
2. Connect the Support Bar to the Cisco IP Phone 7960G.
3. Connect the 7914 Expansion Module to the Support Bar.
4. Connect the Interface Cable.
5. Connect the Power Supply.
6. Connect the Footstand.
Refer to the detailed instructions and corresponding
illustrations that follow for each of these high-level steps.
To ensure a successful installation, verify with your
Caution
system administrator that your phone is ready for
the 7914 Expansion Module and that
Cisco CallManager is installed and configured for
the 7914 Expansion Module. Make sure that you
have all of the parts that you need (see the "Before
You Begin" section on page 2).
6