Charging The Battery; Maintenance And Cleaning; Technical Data - Black & Decker KC3610 Original Instructions Manual

Charging the Battery

Charging as shown, Must turn o the
screwdriver. Only Red lights up on the
power indicator when you charging.
Charging time: 1-3 Hours.
Inserting Tool Bits
Important! Always Turn o the machine
before you change the screw bit to avoid
unintentional starting of the machine.
On/O Trigger.
On/O Trigger
Use the On/O trigger to start the machine
and keep holding it for continuous
operation.
Operation for working
1. Using the Screwdriver as a Screw-driver
Before using the machine check whether
the screw-bit is inserted correctly. Avoid
over-tightening screws, otherwise the screw
head may be damaged or stripping of the
threads may occur.
2. Screw Insertion
Set the direction of rotation of the
screwdriver to the clockwise direction.
Insert the screw-bit into the slot in the head
of the screw. Hold the screw bit
perpendicular to the head of the screw,
otherwise the screw or the screw head may
be damaged. Press the screw bit against the
screw with a constant pressure while driving
in the screw. When the screw is completely
screwed in, hold the machine firmly and
release the On/O trigger, otherwise the
screw or the screw head may be damaged.
If the On/O trigger is not released
immediately a high torque could also
damage the screwdriver bit or the
screwdriver.
3. Screw Removal
Set the direction of rotation of the
screwdriver to the anticlockwise direction.
Insert the screw-bit into the slot in the head
of the screw. Hold the screw-bit
perpendicular to the head of the screw,
otherwise the screw or the screw head may
be damaged. Press the screw bit against the
screw with a constant pressure while
removing the screw.
(Original instructions)

Maintenance and Cleaning

Attention! Always remove the battery before
carrying out any work on the machine.
To clean, always use a dry or moist, but not
wet, towel. Many cleaning agents contain
chemical substances which may cause
damage to the plastic parts of the machine.
Therefore do not use any strong or
inflammable cleaners such as petrol, paint
thinner, turpentine or similar cleaning agents.
Always keep air ventilation holes free of dust
deposits to prevent overheating.
Batteries
BLACK+DECKER batteries can be
recharged many times. At the end of
their useful life, discard batteries with
due care for our environment:
• Run the battery down completely, then
remove it from the tool.
• NiCd, NiMH and Li-Ion batteries are
recyclable. Take them to any authorised
repair agent or a local recycling station.

Technical data

Rated Voltage
No load speed
Weight
Battery cell
Charger
Rated Voltage
Output Voltage
Charging Time
Charger
Input Voltage
Output Voltage
Output Current (DC)
ENGLISH
KC3610
V 3.6
-1
min 200
kg 0.26
V 1.2 Ni-cd 600 mAh
HY-06
V 220-240
DC6V, 200 mA
1-3 hour
HY06 Type2 /
HY06 Type1
V 230
AC
V 6
DC
mA 300
7