Display Settings - Panasonic CQ-VX100W Operating Instructions Manual

Troubleshooting
■
Common (continued)
Output
disabled/distorted
37
video/audio.
■

Display Settings

The picture is dark. The
picture is whitish. Something
is wrong with the picture.
The picture is light in color.
The display does not go
back into the unit.
■
Radio
Poor reception or noise
The number of auto
preset stations is less
than 6.
Preset stations cannot
be stored.
■
CD
No playback or disc
ejected
Sound skipping or noise
Sound skipping due to
vibration
Disc unejectable
38
CQ-VX100W
(continued)
The conversion cable for AV 1 IN supplied with this unit is not used for the
terminal of AV1 IN.
aUse the conversion cable for AV 1 IN supplied with this unit for the
connection.
The screen is not adjusted properly.
aMake every adjustment of the screen.
The monitor stops on the way to the home position.
aPress [OPEN].
Antenna installation or wiring of antenna cable is faulty.
aCheck whether the antenna mounting position and its wiring are correct. In
addition, check to see whether the antenna ground is securely connected to
the chassis.
No power is supplied to the antenna amplifier (when using a film antenna, etc.).
aCheck the wiring of the antenna power lead.
The number of receivable stations is less than 6.
aMove to an area where receivable stations number is maximum, and try pre-
setting.
The contact of the battery lead is poor, or the battery lead is not always powered.
aMake sure that the battery lead is connected securely, and preset stations
again.
The disc is inserted upside down.
aInsert a disc correctly.
There is a flaw or foreign object on the disc.
aRemove the foreign object, or use a flawless disc.
There is a flaw or foreign object on the disc.
aRemove the foreign object, or use a flawless disc.
The unit is not sufficiently secured.
aSecure the unit to the console box.
The unit is tilted at over 30˚ in the front-to-end direction.
aMake the angle 30˚ or less.
Something such as a peeled label obstructs the disc coming out.
aPress and hold the [ u ] for more than 10 seconds (disc forced ejection). In
case that the disc forced ejection does not work, consult your dealer.
The microcontroller in the unit operates abnormally due to noise or other factors.
aUnplug the power cord and plug it again. In case the unit is still out of order,
consult your dealer.