Advertisement
Thermistor
o
Temp F
Ω
50
20KΩ
60
15.8KΩ
77
10KΩ
85
8KΩ
95
6.5KΩ
115
4.3KΩ
140
2.5KΩ
160
1.7KΩ
175
1.3KΩ
200
850Ω
Special Test Mode:
While in Power Off, pressing the Dryness Level + Power keys simultane-
ously will put the dryer into the System Check mode
" t2 " will display.
System Check Mode Progress
t2 mode Function Performed Start/Pause Motor(CW) Relay On → Heater
Relay On → Heater Relay Off → Motor(CW) Relay Off (Circulation)
Caution!
Do not give it too much testing time. It will over-burden
the Main PCB.
Sensor Bar Touch Data Mode
How to Enter:
Start Dryer tumbling, Press Temp + Signal for 3 seconds
during the drying process.
Open door, touch both sensor bars with wet cloth, sensor
hit numbers show in display.
Note: Test mode subject to change without notice
Cycle Count Test Mode
How to Enter:
Press Signal + Wrinkle Prevent Keys for 3 sec during
Power On State.
Press Signal key for 3 seconds (until beep)
Note: Test mode subject to change without notice
Software Version Test Mode
How to Enter:
Press Signal + Wrinkle Prevent Keys for 3 sec during
Power On State.
Press Temp key for 3 seconds (until beep)
Note: Test mode subject to change without notice
Dryer continues to run after cycle completed
Wrinkle Prevent option provides approximately 90 minutes of intermittent tumbling
in unheated air at the end of the cycle to reduce wrinkling.
Press the Wrinkle Prevent button to activate this feature.
The indicator light above the pad will illuminate when Wrinkle Prevent is selected.
Chasing lights appear in the display when the Wrinkle Prevent option is selected.
The load is dry, and can be removed at any time during the Wrinkle Prevent cycle.
Electrical Dryers 240 VAC, 60 Hz, 30 Amps, 3-wire or 4-wire installations
Gas Dryers 120 VAC, 60 Hz, 15 Amps, 3-wire installations
Do not use dryer to dry clothes which have traces of any flam-
mable substance, such as vegetable oil, cooking oil, machine
oil, flammable chemicals, thinner, etc., or anything containing
wax or chemicals, such as mops and cleaning cloths. Flamma-
ble substances may cause fabric to catch fire by itself.
Door Switch
Temperature Test Diagnostic Mode
How to Enter:
Press Signal + Wrinkle Prevent Keys for 3 sec during
Power On State.
Press Time + Wrinkle Prevent Keys and 7-segment will
display the temperature in Celsius.
Compare vent temp to drum temp to see air flow.
Location consideration In the USA
•
All Dryers Must be vented to the outside.
•
Only rigid or flexible metal duct should be
used for venting.
COM (Wht)
NO (Yel)
NC
:
5
Advertisement
