CONTENTS Safety information Care and cleaning Safety instructions Troubleshooting Operation Installation Daily Use Technical information Hints and tips Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
Do not use mechanical devices or other means to accelerate • the defrosting process, other than those recommended by the manufacturer. Do not damage the refrigerant circuit. • Do not use electrical appliances inside the food storage • compartments of the appliance, unless they are of the type recommended by the manufacturer.
Care and cleaning electrician to change the electrical components. WARNING! Risk of injury or • The mains cable must stay below the damage to the appliance. level of the mains plug. • Connect the mains plug to the mains • Before maintenance, deactivate the socket only at the end of the installation.
A medium setting is generally CAUTION! If the ambient the most suitable. temperature is high or the However, the exact setting appliance is fully loaded, and the should be chosen keeping in appliance is set to the lowest mind that the temperature inside temperatures, it may run the appliance depends on: continuously causing frost to...
CrispFresh drawer If “OK” is displayed (A), put fresh food into area indicated by symbol, if not (B), adjust The drawer is suitable for storing fruit and the temperature controller to a colder vegetables. setting and wait 12 hours before checking the temperature indicator again.
• Fruit and vegetables: these should be • Bottles: these need a cap and should be thoroughly cleaned and placed in the stored on the door bottle shelf, or (if special drawer(s) provided. equipped) on the bottle rack. • Butter and cheese: these should be •...
Periods of non-operation WARNING! If the cabinet will be kept on, ask somebody to When the appliance is not in use for long check it once in a while to periods, take the following precautions: prevent the food inside from 1.
Problem Possible cause Solution The water drainage plug is Position the water drainage not correctly positioned. plug in the correct way. Food products are not Wrap the food products better. wrapped properly. Temperature is set incor- Refer to "Operation" chapter. rectly.
maximum power is shown on the light bulb cover). 4. Reassemble the lamp cover. 5. Connect the plug to the mains socket. Open the door. Make sure that the light comes on. Closing the door 1. Clean the door gaskets. 2.
min. 5 cm 200 cm min. 200 cm 6. Install the spacer. 7. Install the door. CAUTION! Refer to the 8. Tighten the upper pin. assembly instructions for the installation. Installing the appliance Door reversibility CAUTION! Make sure that the mains cable can move freely.
Page 12
8. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in 4. Push the appliance in the direction of opposite case. the arrows (2) against the cupboard on the opposite side of the hinge.
Page 13
15. Open the appliance door and the kitchen furniture door at an angle of 10. Install the vent grille (B). 90°. 11. Attach the hinge covers (E) to the hinge. 16. Insert the small square (Hb) into guide 12. Disconnect the parts (Ha), (Hb), (Hc) (Ha).
21. Press the part (Hd) on the part (Hb). 8 mm 19. Place the small square on the guide again and fix it with the screws Do a final check to make sure that: supplied. • All screws are tightened. 20.
ENVIRONMENT CONCERNS dispose appliances marked with the symbol Recycle the materials with the symbol with the household waste. Return the Put the packaging in applicable containers product to your local recycling facility or to recycle it. Help protect the environment contact your municipal office.
Need help?
Do you have a question about the S7212LS2P and is the answer not in the manual?
Questions and answers