Black & Decker BDCDD18 Manual page 6

ENGLISH
Additional safety instructions for batteries and
chargers (Not provided with the tool)
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C
u
and 40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions
u
p
given in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
Use your BLACK+DECKER charger only to charge
u
the battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
6
(Original instructions)
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Chuck
4. Torque adjustment collar
5. Battery (not included, sold separately)
6. Bit holder
Fig. A (Not included, sold separately)
5. Battery
7. Charger
8. Charger indicator
Assembly
Warning! Before assembly, remove the battery from the
tool.
Fitting and removing the battery (fig. B)
To fit the battery (5), line it up with the receptacle on
u
the tool. Slide the battery into the receptacle and push
until the battery snaps into place.
To remove the battery, push the release button (9)
u
while at the same time pulling the battery out of the
receptacle.
Fitting and removing a drill bit or screwdriver
bit (fig. C)
This tool is fitted with a keyless chuck to allow for an easy
exchange of bits.
Grasp the rear half of the chuck (3) with one hand
u
and use your other hand to rotate the front half in the
counterclockwise direction, as viewed from the chuck
end.
Insert the bit shaft (10) into the chuck.
u
Firmly tighten the chuck by holding the rear half of the
u
chuck and rotating the front portion in the clockwise
direction as viewed from the chuck end.