Motion Detection Setup Wizard - D-Link DCS-2630L User Manual

Section 3 - Configuration
This wizard will guide you through a step-by-step process to configure the motion
detection feature of your new D-Link Camera
Click Next to continue.
Enabling the Video Motion option will allow your camera to use the motion detection feature.
You may draw areas for your camera to monitor for motion..
Enable Video
Select this box to enable the video motion detection feature of your
Motion: camera. Make sure you draw an area for the camera to monitor for motion.
Enable PIR: When this option is selected, the camera will use PIR (passive infrared) to
detect motion. Use the PIR Sensitivity drop-down box to determine how
sensitive the PIR sensor will be to motion.
Sensitivity: Specifies how sensitive video motion detection will be from 0% to 100%.
A low sensitivity setting means that there must be large changes between
two images in order to detect motion, and a high sensitivity setting means
that even small changes will cause motion to be detected.
Drawing Mode:
Select Draw Motion Area to select the area of the picture to monitor for
movement to trigger recording or a snapshot. Use your mouse to click
and drag on the area that you would like to monitor for motion. Select
Erase Motion Area to clear a selected region and stop the camera from
monitoring that area of the picture.
Clear:
Clears all motion detection areas from the picture.
Click Save Settings to save your changes.
D-Link DCS-2630L User Manual

Motion Detection Setup Wizard

24