Local Network - D-Link DSL-2790U User Manual

Section 4 - Configuration
This optional section allows you to configure the local network and DHCP settings of your device. The DHCP service supplies IP
settings to clients configured to automatically obtain IP settings that are connected to the device through the Ethernet port.
Interface Group:
Select the interface group used locally by the router. Leave this as
the default if you are not sure.
Router IP Address: Enter the IP address of the router. The default IP address is 192.168.1.1.
Note: If you change the IP address, once you click Apply you will need
to enter the new IP address in your browser in order to access the
configuration utility.
Subnet Mask: Enter the subnet mask. The default subnet mask is 255.255.255.0.
Configure If you wish to add another IP address to use to configure the router,
the second IP check this box and enter the IP address and subnet mask.
Address...:
DHCP SERVER SETTINGS (OPTIONAL)
Enable/Disable
By default, DHCP is enabled. You can disable DHCP if required.
DHCP Server:
DHCP IP Address Enter the starting and ending IP addresses for the DHCP server's IP
Range: assignment.
DHCP Lease Time: Note: If you statically (manually) assign IP addresses to your
computers or devices, make sure the IP addresses are outside of
this range or you may experience an IP address conflict.
Click Apply when you are done.
D-Link DSL-2790U Wireless N300 ADSL2+ Modem Router User Manual

Local Network

ROUTER SETTINGS
41