Desa VSGF28NTF Owner's Operation And Installation Manual page 17

Unvented (vent-free) gas fireplace system
Hide thumbs Also See for VSGF28NTF:
Table of Contents

Advertisement

PRESSURE TESTING FIREPLACE GAS
CONNECTIONS
1. Open equipment shutoff valve (see Figure
21, page 16).
2. Open main gas valve located on or near
gas meter for natural gas or open pro-
pane/LP supply tank valve.
3. Make sure control knob of fireplace is in
the OFF position.
4. Check all joints from equipment shutoff
valve to gas control valve (see Figures
22 or 23, page 16). Apply noncorrosive
leak detection fluid to all joints. Bubbles
forming show a leak.
5. Correct all leaks at once.
6. Light fireplace (see Operation, page 18).
Check all other internal joints for leaks.
7. Turn off fireplace (see To Turn Off Gas to
Appliance, page 19, depending on your
model).
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: Do not remove
the data plates attached to the
heater base assembly. The data
plates contain important safety
and warranty information.
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place bottom log in center of the base as-
sembly as shown in Figure 24.
2. Rest rear log in back corner sections of
base assembly as shown in Figure 24.
Make sure log is completely vertical and
not leaning in toward burner where the
flame will touch the log.
3. Position front right log against right side
of grate prongs (see Figure 24).
119303-01E
insTallaTion
Continued
4. Position front left log against left side of
grate prongs (see Figure 24).
5. Place middle right log over front right and
bottom logs as shown in Figure 25. Be sure
hole in middle right log seats over pin in
bottom log.
6. Place middle left log over front left and
bottom logs as show in Figure 25. Be sure
hole in middle left log seats over pin in front
left log.
7. Install fireplace screen by slipping notches
of fireplace screen over screws on front
of fireplace (see Figure 26, page 18).
Grate
Prongs
Middle Left Log
Pin on Front
Left Log
www.desatech.com
Front
Left Log
Base
Assembly
Figure 24 - Installing Bottom Logs
Figure 25 - Installing Top Logs
Rear Log
Bottom
Log
Front Right
Log
Middle
Right Log
Bottom
Log
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vsgf28ptf

Table of Contents