Advertisement
154567/2037-220
5/17/02
1:34 PM
NOTE: Align ribs on inside of depth locator with grooves in clutch housing
before snapping into place.
5. Depth locator is removable by unscrewing dust seal.
Changing Bit Tip
1. Pull forward on adjustment collar and remove it from clutch housing. It
may be quite stiff. (See Figure 3)
2. Use pliers to remove worn bit and install new bit tip.
Depth Adjustment:
Drywall Units (2037-220, 2038-220)
1. Rotate adjustment collar (Figure 4). Clockwise rotation will provide deeper
seating of screws.
2. Test drive a fastener in scrap material to determine if fastener is correctly
seating.
3. Further adjustment may be necessary to increase or decrease the fastener
depth.
4. To increase depth, turn adjustment collar so that end of bit extends further
from end of locator.
5. To decrease depth, turn adjustment collar so that end of bit is closer to the
end of locator.
Page 3
Installing and Changing Nutsetters and Locators
Depth Sensitive Units for Drill Point Screws
1. Select nutsetter size desired.
2. Two locators are supplied, a 9/16" ID for 3/8" nutsetters and 1/2" ID for
3. Drop nutsetter into nose of locator and wrap end of nutsetter until ball lock
4. To change the nutsetter or locator, pull forward on adjustment collar and
3
BIT TIP
DEPTH
HOLDER
LOCATOR
ADJUSTMENT
CLUTCH
BIT TIP
HOUSING RETAINING
COLLAR
5/16" nutsetters (1/2" ID supplied on unit). Match locator to desired size
nutsetter or bit holder.
snaps in groove in nutsetter shank.
remove from clutch housing.
LOCATOR
ADJUSTMENT
COLLAR
Figure 3
RING
Figure 4
Advertisement
