NEC MultiSync LCD1980FXi User Manual page 7

Hide thumbs Also See for MultiSync LCD1980FXi:
Table of Contents

Advertisement

Tilt
Grasp top and bottom of the monitor screen with your hands
and adjust the tilt as desired (Figure TS.1).
NOTE: Handle with care when tilting the monitor screen.
Figure TS.1
NOTE: If the tilt function is not available, rotate the screen 90° clockwise until you hear one click.
Remove Monitor Stand for Mounting
To prepare the monitor for alternate mounting method:
1. Disconnect all cables.
2. Place hands on each side of the monitor and lift up to the highest position.
3. Place monitor face down on a non-abrasive surface. (Place the screen on a 36 mm platform so that the stand is parallel with the
surface) (Figure S.1).
4. Remove the two top screws connecting the monitor to the stand (Figure S.2). Turn the stand to 180° counterclockwise (you will
hear two clicks). Remove the screws from the bottom (Figure S.3) and lift off the stand. The monitor is now ready for mounting in
an alternate manner.
5. Reverse this process to reattach stand: tighten the two bottom screws, turn stand 180° counter clockwise (you will hear two clicks),
and tighten two top screws.
NOTE: Use only VESA-compatible alternative mounting method (100 mm pitch).
NOTE: Handle with care when removing monitor stand.
NOTE: When the LCD is in Landscape mode, be sure the two round indents
are at the bottom of the screen (Figure S.4).
Caution: Use the original screws (4 pcs) when mounting to avoid damage to the
monitor and stand. To fulfi ll the safety requirements the monitor must be
mounted to an arm which guaranties the necessary stability to support
the weight of the monitor. The LCD monitor should only be used with an
approved arm (e.g. GS mark).
36 mm
Figure S.1
Figure S.2
Swivel
Grasp both sides of the monitor screen with your hands and
adjust the swivel as desired (Figure TS.2).
Figure TS.2
Figure S.3
5
1-7
Figure S.4

Advertisement

Table of Contents
loading

Table of Contents