Installing / Removing The Appliance - Miele CS 1012 Operating And Installation Instructions

Installing the appliance(s)
^ Feed the connection cable down
through the cut-out.
^ Starting at the front, position the
appliance in the worktop cut-out.
^ Using both hands, press down
evenly on the sides of the appliance
until it clicks into position. When
doing this make sure that the seal
under the appliance sits flush with
the worktop on all sides. This is
important to ensure an effective seal
all round. Do not use sealant.
When installing several appliances, a
sealing strip must be fitted into each
spacer bar.
^ Push the appliance to the side until
the long slots in the spacer bar can
be seen.
^ Fit the sealing strip d into the long
slots in the spacer bar b.
Installing / removing the appliance(s)
^ Starting at the front, position the next
^ Connect each appliance to the mains
^ Check that each appliance works
Removing the appliance
If the appliance is accessible from
below, it can be pushed up and out of
the cut-out. It must be pushed up from
the back first.
If the appliance is not accessible from
below, take hold of the appliance with
both hands at the back, pull it forwards,
then lift it up and out.
appliance in the worktop cut-out.
(see "Electrical connection").
correctly.
39