Installing the appliance
Weight of the furniture door
Before fitting a furniture door, ensure
that the weight of the door does not
exceed the maximum permitted:
Maximum weight of
F 9122 Ui-2
Fitting a door which is heavier than
the maximum permitted could
damage the hinges.
To install the appliance, you will need
the following tools:
All fitting instructions given are for a
right-hand hinged appliance. If you
have converted the appliance to left-
hand hinging, you will need to adapt
these instructions accordingly.
Positioning the appliance
The feet should be almost fully
screwed in when you push the
appliance into the niche. Otherwise
the feet could break off.
When pushing the appliance into
its niche make sure that the mains
cable does not get trapped.
Move the appliance carefully on
floors that are sensitive to scratching
to prevent damage.
Danger of frost and condensate
accumulation and faults occurring.
If an all round gap of 42 mm is not
maintained between the appliance
casing and the front edge of the
housing unit side walls, the door may
not shut properly.
Tip: Before pushing the appliance into
the niche the two rear feet should be
loosened by half a turn. After pushing it
into the niche the feet will be easier to
adjust from the front (see "Aligning the
Position the mains electricity cable so
that the appliance can be connected
easily once installed.
Push the appliance into its building-in
Align the appliance so that the front
edges of the top and bottom hinges
are flush with the front edge of the
housing side wall.