Inserting Shot Marks Into Clips; Displaying The P2 Card Status - Panasonic AG-HPG10P Operating Instructions Manual

Inserting shot marks into clips

You can differentiate one clip from all the other clips by inserting shot marks.
1
Display the thumbnail display screen.
2
Using [FF] or [REW], move the cursor to the target clip.
3
Press [USER] in which the shot mark function was allocated. (page 25)
To release a shot mark, repeat the above steps.
• If the video data created by a shooting session consists of a multiple number of clips, it will not
be possible to set or release the shot marks unless all the P2 cards containing the video data are
inserted into the slots.
• Shot marks cannot be inserted into the clips on a card whose write protect switch is at the PROTECT
position.

Displaying the P2 card status

The statuses of the P2 card slots, operation statuses of the P2 cards and other card information can be
displayed on the screen, and checked.
1
Display the thumbnail display screen.
2
Press [MENU].
3
Using [STOP], [PLAY] and [STILL], select
"PROPERTY" – "PROPERTY SETUP" – "P2
CARD CAP", and press [STILL].
4
Use [STOP] and [PLAY] to select the item to
be set, and press [STILL].
Remaining memory display
REMAIN:
(default value)
Used memory display
USED:
5
Press [MENU].
6
Using [STOP], [PLAY] and [STILL], select
"PROPERTY" – "CARD STATUS", and press
[STILL].
[When REMAIN has been selected]
1 2
4
[When USED has been selected]
1 2
4
7
Press [MENU] - [EXIT] to exit the procedure.
3
3
39