Table of Contents
Advertisement
The remote control works with the projector's
remote sensor.
• Front remote sensor is 3 meters with a 60
• Also a remote signal reflected in the screen etc.
• Since the remote control uses infrared light to send signals to the projector (Class1 LED), be sure to use the
This is the function to properly use when you use two or
three same type projectors at the same time. This function
should be used combining a setup of a projector.
Downloaded From projector-manual.com Toshiba Manuals
Remote Control (continued)
Remote Control (continued)
Operating The Remote Control
CAUTION • Do not disassemble the remote control.
• Do not place the remote control near the projector's lens, fan, or vents.
• Do not drop or otherwise expose the remote control to physical impact.
• Do not get the remote control wet or place it on wet objects on it. Doing so may result in malfunction.
• Remove the batteries from the remote control and store them in a safe place if you
won't be using the remote control for an extended period.
NOTE
• Replace the batteries whenever the remote control starts to malfunction.
• When strong light, such as direct sunlight or light from an extremely close range (such as from an
inverter fluorescent lamp), hits the projector's remote sensor, the remote control may cease to function.
Adjust the direction of the projector to keep light from directly hitting the projector's remote sensor.
degree range (30 degrees to the left and
right of a remote sensor).
Rear remote sensor is 3 meters with a 40
degree range (20 degrees to the left and
right of a remote sensor).
may be available. If it is difficult to send a remote signal to the sensor directly, please try.
remote control in an area free from obstacles that could block the remote control's output signal to the projector.
You can use the remote control as a wired remote control, by connecting the REMOTE CONTROL
memo
ports of the main unit and remote control via an audio cable (3.5 dia. stereo mini cable with plugs).
Using The Remote ID Feature
Set the ID number to the projector beforehand,
1
referring to the item "IR REMOTE ID" of the section
"OPTION Menu".
When the ALL is selected to the item "IR
memo
REMOTE ID" of the OPTION menu, the projector is
controlled by a remote control irrespective of the
position of the ID CHANGE switch.
Slide the knob of the switch into the position of the
2
ID number of the projector you want to control.
approximately
approximately
3 meters
3 meters
LASER INDICATOR
STANDBY/ON VIDEO
RGB
+
+
+
LENS SHIFT
FOCUS
ZOOM
–
–
–
BLANK
ASPECT
LASER
PREVIOUS
NEXT
MOUSE
ID CHANGE
switch
ESC
MENU
POSITION
RESET
AUTO
MAGNFY
PinP
VOLUME
ON
FREEZE
MUTE
OFF
KEYSTONE
SEARCH
1 2 3
ID CHANGE
21
Advertisement
Table of Contents
