Installation Directions - Fetco CBS-2151XTS User Manual

Installation Directions

For professional installation only
Brewer Setup
1. Review the dimensions for the unit and verify that it will fit properly in the space intended for it. Verify that the
counter or table will support the total weight of the brewer and dispensers when filled (specifics-page 23).
2. Place the brewer on the counter or stand
3. For terminal bock electrical connected units: remove the lower utility slide out at the back of the equipment to
access the electrical connections. The utility slide must remain close to the unit.
Note: Utility slide out panel cannot be completely detached from the brewer.
4. Access to the service area is restricted to persons having safety/hygiene knowledge and practical experience of
the coffee brewer. This appliance must be installed in locations where it can be overseen by trained personnel
5. For proper operation, this appliance must be installed indoors where the temperature is between 10°C/50°F to
35°C/95°F. Drain and remove al liquid from equipment and lines if exposed to freezing temperatures
6. All commercial cooking equipment, including this unit, is not intended for use by children or persons with reduced
physical, sensory, or mental capabilities. Ensure proper supervision of children and keep them away from the
unit.
7. All commercial cooking equipment, including this unit, is not intended for use by children or persons with reduced
physical, sensory, or mental capabilities. Ensure proper supervision of children and keep them away from the
unit
8. This unit must be installed and serviced by qualified personnel only.
9. Installation must conform to all local electrical and plumbing codes. Installation by unqualified personnel will void
the unit warranty and may lead to electric shock or burn, as well as damage to unit and/or its surroundings.
10. Review the dimensions for the unit and verify that it will fit properly in the space intended for it. Verify that the
counter or table will support the total weight of the brewer and dispensers when filled (See: Technical Data).
11. Place the brewer on the counter or stand. When the brewer is in position, level it front to back as well as side-to-
side by adjusting the legs.
12. Do not tilt appliance more than 10° to insure safe operation.
13. Unit is for protected indoor use only. Do not steam clean or use excessive water on unit.
14. This unit is not "jet-proof" construction. Do not pressure wash or use jet spray to clean this unit.
15. The unit is not waterproof-do not submerge or saturate with water.
Do not operate if unit has been submerged or saturated with water.
Equipment exposed to flood and contaminated must never be used due to electrical and food safety.
General:
Utilize only qualified beverage equipment service technicians for installation.
A Service Company Directory may be found on our web site, http://www.fetco.com.
Water Connection
1. This equipment is to be installed to comply with the applicable federal, state, or local plumbing codes.
2. Water supply inlet is a ⅜ inch male flare fitting
3. The brewer can be connected to a cold water line.
(Cold water is preferred for best beverage flavor, but hot water will allow for greater output.)
4. Install a shut off water valve near the brewer to facilitate service.
5. An in-line water filter should used. Install filter unit after the water shut off valve and in a position to facilitate filter
replacement.
6. Flush the water supply line and filter before connecting it to the brewer.
7. Verify that the water line will deliver at least 1½gpm/(5.7lpm) per minute and a flow rate of at least
1½gpm/(5.7lpm)
connections.
8. Use a wrench on the factory fitting when connecting the incoming water line. This will reduce stress on the
internal connections and reduce the possibility of leaks developing after the install has been completed
per minute and water pressure is between 20-75 psig (138-517kPa) before making any
16