Makita LS1216 Instruction Manual page 10

angle 45 degrees and miter angle right 45
degrees).
A) When you obtain correct size on the left side of
workpiece
Shift the laser line to the left of the blade.
•
B) When you obtain correct size on the right side of
workpiece
Shift the laser line to the right of the blade.
•
Align the cutting line on your workpiece with the laser
line.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Socket wrench storage
1
009495
The socket wrench is stored as shown in the figure.
When using the socket wrench, pull it out of the wrench
holder. After using the socket wrench, return it to the
wrench holder.
Installing or removing saw blade
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the blade.
Use only the Makita socket wrench provided to
•
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening of
the hex bolt. This could cause an injury.
009483
1. Wrench holder
2. Socket wrench
2
1. Stopper pin
1
Lock the handle in the raised position by pushing in the
stopper pin.
1
2
009497
To remove the blade, use the socket wrench to loosen
the hex bolt holding the center cover by turning it
counterclockwise. Raise the blade guard and center
cover.
009498
Press the shaft lock to lock the spindle and use the
socket wrench to loosen the hex bolt clockwise. Then
remove the hex bolt, outer flange and blade.
3
009500
10
1. Center cover
2. Socket wrench
3
3. Hex bolt
4. Blade guard
4
1. Shaft lock
2. Blade case
3. Hex bolt
1
2
3
1. Arrow
1 2
2. Arrow
3. Blade case
4. Saw blade
4