Esse WN Installation Instructions

Woodfired cooker

Advertisement

Quick Links

INFORMATION FOR USE WHEN ORDERING SPARES:
Cooker Model:
Serial Number:
Colour:

Technical Information

Nominal heat output kW
Boiler heat output kW
3
Combustion air requirement m
/h
2
Air vent size cm
Weight of appliance Kg
Minimum chimney draught Pascals
Mean flue gas temperature °C
Flue gas mass flow g/s
This appliance is not suitable for installation in a shared flue system
Ouzledale Foundry Co. Limited, Long Ing, Barnoldswick, Lancashire BB18 6BN
Tel: 01282 813235 Fax: 01282 816876 Email: esse@ouzledale.co.uk Website: http://www.esse.com
THE ORIGINAL CAST IRON COOKER
02/07
???
???
???
???
???
???
???
???
ESSE Woodfired Cooker
INSTALLATION INSTRUCTIONS
MODEL: WN, WD, W25
THIS APPLIANCE MUST BE COMMISSIONED BY A CORGI REGISTERED ENGINEER
THE WARRANTY CARD MUST BE RETURNED TO ENSURE GUARANTEE VALIDITY

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WN and is the answer not in the manual?

Questions and answers

Summary of Contents for Esse WN

  • Page 1 This appliance is not suitable for installation in a shared flue system Ouzledale Foundry Co. Limited, Long Ing, Barnoldswick, Lancashire BB18 6BN Tel: 01282 813235 Fax: 01282 816876 Email: esse@ouzledale.co.uk Website: http://www.esse.com THIS APPLIANCE MUST BE COMMISSIONED BY A CORGI REGISTERED ENGINEER...
  • Page 2 Be terminated at least 1m above roof level The chimney must be capped to prevent GENERAL INFORMATION so that the chimney does not terminate in a ingress of rain. pressure zone. In the UK, the installer has a responsibility under the Health and Safety at Work Act 1974 to provide for A flue/chimney access point may also be If the appliance is installed as a freestanding required so that the state of the chimney can...
  • Page 3 CHIMNEY AND FLUE INSTALLING THE APPLIANCE 1) Pressure and suction zones created by wind FLUE CONNECTION The flue pipe used to connect the appliance to the chimney is 6” (150mm) in diameter. The flue connection is on the top of the appliance, in the centre at the back. IMPORTANT INSTALLATION NOTES 1.
  • Page 4 HOT WATER SYSTEMS Typical DHW Gravity System WD & W25 MODELS OPEN VENT OPEN VENT A) There are two connections, both 1” BSP Female (Rp1) – on the left hand side for hot water. The storage cylinder should be 30-gallon nominal capacity insulated to prevent heat loss and as close to the cooker as possible.

Table of Contents