Saving money and the environment
Adjusting Sleep Mode
1
From the printer control panel, navigate to:
> Settings >
2
Set the time that the printer stays idle before it enters Sleep Mode.
3
Apply the changes.
Using Hibernate mode
Hibernate is an ultra‑low‑power saving mode.
Notes:
•
Three days is the default amount of time before the printer enters Hibernate mode.
•
Make sure to wake the printer from Hibernate mode before sending a print job. A hard reset or a long
press of the Sleep button wakes the printer from Hibernate mode.
•
If the printer is in Hibernate mode, then the Embedded Web Server is disabled.
1
From the control panel, navigate to:
> Settings >
2
Select Press Sleep Button or Press and Hold Sleep Button, and then press
3
Press Hibernate >
Adjusting the brightness of the printer display
To save energy, or if you have trouble reading the display, adjust its brightness settings.
Using the Embedded Web Server
1
Open a Web browser, and then type the printer IP address in the address field.
Notes:
•
View the printer IP address in the TCP/IP section in the Network/Ports menu. The IP address appears
as four sets of numbers separated by periods, such as 123.123.123.123.
•
If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2
Click Settings > General Settings.
3
In the Screen Brightness field, enter the brightness percentage you want for the display.
4
Click Submit.
> Settings >
> General Settings >
> Settings >
> General Settings >
.
> Timeouts >
> Sleep Mode >
.
84