Repeating Defects Appear On Prints; Print Is Too Dark - Dell S2830dn User Manual

Troubleshooting

Repeating defects appear on prints

Action
Step 1
Measure the distance between the defects.
Check for a distance between the defects that equals:
•
97 mm (3.82 in.)
•
47 mm (1.85 in.)
•
38 mm (1.5 in.)
Is the distance between defects equal to one of the listed
measurements?
Step 2
Replace the imaging unit, and then resend the print job.
Do the repeating defects still appear?

Print is too dark

Action
Step 1
a
From the Quality menu on the printer control panel, reduce the
toner darkness.
Note: 8 is the factory default setting.
b
Resend the print job.
Is the print still too dark?
Yes No
Go to step 2.
Contact technical The problem is
support or your Dell solved.
printer dealer.
Yes No
Go to step 2. The problem is
solved.
134
1
Check if the
distance
between the
defects equal to
80 mm (3.15 in.)
2
Take note of the
distance, and
then contact
technical
support or your
Dell printer
dealer.