User (U) / Jam (J) / Machine (E) Error Codes; User Error Codes (U Codes) / Machine Error Codes (E Codes) - Panasonic Workio DP-C305 Operating Instructions Manual

User (U) / Jam (J) / Machine (E) Error Codes

User Error Codes (U Codes) / Machine Error Codes (E Codes)

<Outer>
ADF Cover
Finisher Top
Cover (Option)
Transport
Cover
(Option)
Battery
Holder
Front Cover
User Error (Locations)
Error Location Indicator
E Codes:
Call the authorized Panasonic dealer when
machine Error Code (E Code) appears on the
Touch Panel Display.
Code
U1 Front Cover is open.
U4 Finisher is pulled out.
U6 ADU Cover, Feed Cover 1, and/or Right Side
Cover is open.
U7 Feed Cover 2 & Option Feed Cover are
open.
U8 Transport Cover is open.
(When optional Paper Transport Unit is
installed)
U11 Paper remains in the Finisher Bin.
(When optional Finisher is installed)
U12 Finisher Top Cover and/or Staple Cover is
open.
(When optional Finisher is installed)
NOTE*
A. When the Maintenance and Toner/Toner Waste Container Indicators are blinking
The machine will complete the current job and stop operating. To continue using the machine temporarily while waiting for a
replacement toner/container, press any key. (Ex: For Toner Waste Container, approximately 300 additional copies can be made.)
B. When the Maintenance and Toner/Toner Waste Container Indicators light up
The machine stops and will not allow further operation until the Toner Waste Container is replaced.
64
ADF
(Automatic Document Feeder)
Section
●
When a user error occurs, the location and the procedures for handling
the user error are displayed frame by frame on the Touch Panel Display.
Check the location and handle the user error according to the
displayed pictures and this manual. (See pages 78 to 83)
Ex: Front Cover is
opened.
Check Points
<Inner>
Toner Cartridges
(Yellow/Magenta/Cyan/Black)
Right Side
Cover
Feed Cover 1
ADU Cover
Feed Cover 2
Toner Waste Container
Option Feed
Cover
Ex: Toner Waste Container
is almost full.
●
Select "Close" to
continue the current
job temporarily.
Code
U13* Toner level is low, or has run out.
(See pages 16, 78, and 79)
U14* Toner Waste Container is full.
(See pages 16, 82, and 83)
U15 Toner Waste Container is not installed.
(See pages 82 to 83)
U20 ADF Cover is open.
U21 ADF is open while scanning from ADF.
U25 Toner is hardened. Shake Toner Cartridge
well. (See page 78)
U28 OPC Drum Unit is not installed.
(See pages 80 to 81)
U29 OPC Drum Unit requires replacement.
(See pages 80 to 81)
OPC Drum Units
(Yellow/Magenta/Cyan/Black)
Ex: Toner Waste
Container is full.
●
Machine will stop.
Replace the Toner
Waste Container.
Check Points