Using the auxiliary wires, connect a 12 V battery to the
meter unit connector terminals.
Battery Positive Terminal (+) → Terminal 
Battery Negative Terminal (–) → Terminal 
Using the auxiliary wires, connect the battery positive wire
to terminal .
Verify that all the LCD segments (the letters and numbers
of the liquid crystal display) to appear for 3 seconds. Then
the clock or meters operates normally depending on the
Check that disconnecting the terminal  causes all the
LCD segments to become unlit.
If there is any problem, replace the speedometer assem-
If an oscillator is unavailable, check the speedometer as
Install the meter unit.
Raise the rear wheel off the ground with jack (see Rear
Wheel Removal in the Wheels/Tires chapter).
Turn the ignition switch ON.
Turn the rear wheel by hand to see if the speedometer
shows the vehicle speed [A] that corresponds to the wheel
If it does not show properly, inspect the speed sensor and
power to the speed sensor.
If the speed sensor and power to the speed sensor are
normal, replace the meter assembly.
ELECTRICAL SYSTEM 16-87