16-84 ELECTRICAL SYSTEM
Remove the wedge-base type bulb [A] by pulling the bulb
straight out of the socket [B].
Do not turn the bulb. Pull the bulb out to prevent
damage to the bulb. Do not use bulb rated for other
than voltage or wattage specified in the wiring dia-
Meter Unit Assembly
Connect the connector of the indicator panel to the
Put in the oil pressure warning light (LED) [A] and FI indi-
cator light (LED) [B] to the lower meter cover.
Oil Pressure Warning Light (LED): Orange Lead and
FI Indicator Light (LED) : Red Lead and White Lead
Fit the speedometer and indicator panel onto the lower
Put the holes [A] onto the projections [B] of the lower me-
Tighten the screws.
Install the upper meter cover, and tighten the screws.
Meter Unit Inspection
Mode Selection and Reset Button Checks
When the ignition switch is turned ON, all the LCD seg-
ments (the letters and numbers of the liquid crystal dis-
play) [A] appear for 3 seconds on the meter.
If they do not appear, check the LCD segments.
Check that the display [A] changes to the CLOCK, ODO,
and TRIP display each time the mode select button [B] is
If the display doesn't change in the order specified, re-
place the speedometer assembly.