Install the washer so that the OUTSIDE mark [A] faces
Replace the clutch hub nut with a new one.
Apply molybdenum disulfide oil solution to seating surface
of the hub nut.
Holding the clutch hub, tighten the clutch hub nut.
Special Tool - Clutch Holder: 57001-1243
Torque - Clutch Hub Nut: 130 N·m (13.3 kgf·m, 96 ft·lb)
Install the friction plates and steel plates, starting with a
friction plate and alternating them.
Install the friction plates so that the plates of having more
lining blocks [A] than other plate [B] are placed at both
If new dry friction plates and steel plates are in-
stalled, apply engine oil to the surfaces of each
plate to avoid clutch plate seizure.
Install the last friction plate [A] fitting the tangs in the
grooves in the housing as shown in the figure.
Install the clutch spring plate and springs, and tighten the
clutch spring bolts.
Torque - Clutch Spring Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Install the right engine cover (see Right Engine Cover In-
Clutch Plate, Wear, Damage Inspection
Visually inspect the friction and steel plates for signs of
seizure, overheating (discoloration), or uneven wear.
Measure the thickness of each friction plate [A] at several
If any plates show signs of damage, or if they have worn
past the service limit, replace them with new ones.
Friction Plate Thickness
13088-0023 2.9 ∼ 3.1 mm (0.1141 ∼ 0.1220 in.)
13088-1133 2.92 ∼ 3.08 mm (0.1149 ∼ 0.1212 in.)
Service Limit: 2.8 mm (0.110 in.)