3-106 FUEL SYSTEM (DFI)
Prepare a fuel hose of the inside diameter 7.5 mm (0.30
in.) and a measuring cylinder.
Seat (see Seat Removal in the Frame chapter)
Fuel Tank Bolts (see Fuel Tank Removal)
Raise the fuel tank.
Stuff a clean shop towel around the fuel outlet hose joint.
While pinching the locks of the hose joint with fingers,
disconnect the joint (see Fuel Tank Removal) and insert
the fuel hose [A] quickly onto the tank outlet pipe.
Secure the fuel hose with a clamp [B].
Run the other side of the fuel hose into the measuring
Temporarily install the fuel tank and close the fuel tank
Wipe off spilled out fuel immediately.
Be sure to hold the measuring cylinder vertical.
With the engine stopped, turn the ignition switch ON. The
fuel pump should operate for 3 seconds, and then should
stop. Repeat this several times until the fuel hose is filled
Measure the discharge for 3 seconds with the fuel hose
filled with fuel.
Amount of Fuel Flow
50 mL (1.7 US oz.) or more for 3 seconds
If the fuel flow is much less than the specified, check the
battery condition (see Charging Condition Inspection in
the Electrical System chapter). If the battery is good, re-
place the fuel pump.
After inspection, connect the fuel hoses, and install the
fuel tank (see Fuel Tank Installation).
Start the engine and check for no fuel leakage.