Protecting Against Unauthorised Access; Resetting The Base To The Default Settings - Gigaset E500 Manual

Base settings
¤ q Settings ¤
§Menu§
¤ q System ¤
¤ q Repeater Mode
¤
§OK§
(³= activated)
After activating or deactivating the
repeater, switch your handset off
and on again (¢ page 24).
Please note
u Eco Mode / Eco Mode+
(¢ page 42) and repeater sup-
port cancel each other out i.e.,
if you use a repeater, you can-
not use Eco Mode or Eco
Mode+.
u The default encrypted trans-
mission setting is deactivated
when repeater mode is acti-
vated.
Protecting against
unauthorised access
Protect the system settings of the
base with a system PIN known only
to yourself. You will need to enter
the system PIN when, for example,
registering/de-registering a handset
to/from the base.
Changing the system PIN
You can change the base's 4-digit
default system PIN ("0000") to a
4-digit PIN known only to yourself.
¤ q Settings ¤
§Menu§
¤ q System ¤
¤ q System PIN ¤
¤ System PIN: (enter the current
system PIN) ¤
§OK§
(enter your new system PIN) ¤
50
§OK§
§OK§
§OK§
§OK§
§OK§
¤ New PIN:
§OK§
Resetting the system PIN
If you have forgotten your system
PIN, you can reset the base to the
original code 0000:
Disconnect the power cable from
the base. Hold down the registra-
tion/paging key on the base while
reconnecting the power cable to the
base. Hold down the key for at least
5 seconds.
The base has now been reset and
the system PIN set to 0000.
Please note
All handsets are de-registered
and must be re-registered. All set-
tings are reset to the default set-
tings.
Resetting the base to the
default settings
When the settings are restored:
u Date and time are retained
u Handsets are still registered
u Eco Mode is activated and Eco
Mode+ is deactivated
u The system PIN is not reset.
¤ q Settings ¤
§Menu§
¤ q System ¤
¤ q Reset Base ¤
§OK§
§OK§
§OK§