Connecting The Brine Piping; About Connecting The Brine Piping; Precautions When Connecting The Brine Piping - Daikin EGSQH10S18AA9W Installer's Reference Manual

NOTICE
Do NOT throw away any bolts. They need to be re-inserted
when transport or heavy manipulation is required.
5 Open the front plate of the unit. If needed, the nylon bands for
lifting can be used.
6 Adjust the height of the 4 leveling feet of the outer frame to
compensate for floor irregularities. The maximum allowed
deviation is 1°.
NOTICE
To avoid structural damage on unit, ONLY move the unit
when levelling feet are at their lowest position.
NOTICE
For optimum sound reduction, carefully check if there is no
gap between the bottom frame and the floor.
7 Adjust the height of the 2 front leveling feet of the inner frame to
compensate for irregularities.
CAUTION
Check that the heat pump module does NOT touch the
outer casing.
EGSQH10S18AA9W
Daikin Altherma ground source heat pump
4P351748-1D – 2016.02
NOTICE
Check if the front support bolts remain levelled and are
NOT stressed. The support feet from outer (b) and inner
frame (c) MUST be adjusted so that those front bolts
remain level. Do NOT adjust support foot (a)!
Bottom view:
Side view:
INFORMATION
To check if the front support bolts are not stressed, loosen
them partly and fix them again afterwards.
≤1°
7.4

Connecting the brine piping

7.4.1

About connecting the brine piping

Before connecting the brine piping
Make sure the indoor unit is mounted.
Typical workflow
Connecting the brine piping typically consists of the following stages:
1 Connecting the brine piping.
2 Filling the brine circuit.
3 Connecting the pressure relief valve to the drain on the brine
side.
4 Insulating the brine piping.
7.4.2 Precautions when connecting the brine
piping
INFORMATION
Also read the precautions and requirements in the
following chapters:
▪ General safety precautions
▪ Preparation
7 Installation
c
b
a
Installer reference guide
25