Never try to clean clothes there could be a danger your machine and contact or footwear on yourself of explosion. If any doubt your Gerni distributor. or other persons. arises, please contact the Hold the spray lance fi rm- local authorities.
Never let any persons well), an additional fi lter Mains power connection stand under the product should be mounted. when stored on the wall. Repair and maintenance WARNING! WARNING! Always remove Inadequate extension The following should be ob- the electric plug from the cables can be dangerous.
2.2 Operation elements See illustration at the end 12 Trolley handle (telescop- and model survey of this manual. ic handle) 13 Hose reel (not standard) 1 Start/stop switch 14 Hose hook 2 Water inlet (with fi lter) 15 Model tag 3 High pressure connec- 16 Quick coupling tion (only models with-...
3.3 Mounting of quick 1. Screw the quick coupling coupling (16)tight on to the water inlet (2). Note: The inlet fi lter must always be fi tted in the wa- ter inlet pipe to fi lter out sand, lime stone and other impurities as these will damage the pump valves.
Page 7
4.2 Mounting of spray 1. Push the spray lance (6) 2. Attach the nozzle. lance and Click & into the spray gun (7) Clean nozzles and twist it on. Warning: When attaching the Click & Clean nozzles, the button on the side of the spray lance should come out again.
Page 8
4.4 Telescopic handle The machine features a tele scopic handle. To raise or lower the handle, press the knob and move the handle upwards or down- wards. When a click is heard, the handle is in right position. 4.5 Start and stop of the The spray lance is affected Do not cover the machine machine (when con-...
Page 9
4.7 Pressure regulation The pressure can be regu- ® ® on the TORNADO lated on the TORNADO PR-nozzle nozzle. High pressure Højtryk Lavtryk Low pressure 4.8 Stationary use If mounting a special wall hook (not standard), the pressure washer can be used as a stationary solu- tion meaning that it can be operated while hanging on...
5 Fields of application and working methods 5.1 General Effi cient high presure cleaning is achieved by following a few guidelines, combined with your own personal experi- ence of specifi c cleaning tasks. Accessories and deter- gents, when correctly chosen, can increase the effi ciency of your pressure washer.
Page 11
5.2 Typical fi elds of application Below you will fi nd a description of a lot of cleaning tasks which can be solved by a pres- sure washer from Gerni in association with accessories and detergents. Task Accessories ‘Click Cleaning method &...
6 After using your pressure washer 6.1 Storing the washer 3. Stop the machine, unplug The machine should be sto- and wind up hose and red in a frost-free room! cable. Pump, hose and accessories 4. Place spray handle, should always be emptied nozzles and other acces- of water prior to storing as sories in the holders of...
7 Maintenance WARNING! Always dis- Clean the connectors of connect the electrical plug dust and sand. Make sure from the socket prior to that no sand or dirt is maintenance or cleaning. blocking the movement To ensure a long and of the button on the Click problem free working life, &...
No water supply Connect inlet water. Water fi lter blocked Clean the fi lter (see section 7.1) Nozzle blocked Clean the nozzle (see section 7.2) In case problems other than the above occur, please contact your local Gerni distributor.
The machine should be for- well as misuse are not warded to one of the serv- covered by the gu a ran - ice centres of the Gerni or- tee). ganisation with description/ that the directions of this spe ci fi ca ti on of the fault.
Page 16
9.3 Accessories Only use original accessories. Click & Clean Special nozzle for enameled surfaces. Optimal dis- Car nozzle tance: 30 - 50 cm. Click & Clean 90° angled special nozzle for undercarriage and wheel Undershassis arches. Integrated guide shoes. nozzle Click &...
Page 17
10 EU Declaration of Conformity EU Declaration of Conformity Product: High Pressure Washer Type: Gerni Super 130.2, Super 140.2 Description: 230 V 1~, 50 Hz - IP X5 The design of the unit EC Machine Directive 98/37/EC corre sponds to the follow-...
Need help?
Do you have a question about the Super 130.2 and is the answer not in the manual?
Questions and answers