Pace Pace4PRM Installation Manual page 3

2. Pace1PTM installation:
a. Secure unit to desired mounting surface with a proper fastening device utilizing the case's mounting hole.
Unit should be mounted in proximity of camera/device.
b. Connect structured cable from IP camera/device to RJ45 jack marked [PoE Out] (Fig. 2, pg. 3).
c. Connect structured cables from Pace4/8/16PRM to RJ45 jack marked [RJ45 Link] (Fig. 2, pg. 3).
Note: The Pace4/8/16PRM is designed to accommodate Megapixel, HD720, HD1080 and VGA (SD) cameras. It is impor-
tant to note that some high resolution and high frame rate cameras may demand faster headend processing ability, such
as a PC graphics card to present a quality image. If the headend processing equipment is insufficient in speed, the image
may show pixelation and latency. It is advisable to pretest system if unsure. Alternatively, frame rate and resolution may
be reduced to accommodate system equipment.
Fig. 1
CAT5 Cable to
Pace1PTM
OUT
Ports
1 4
IN
Pace8PRM
(front)
Structured
Cable from
midspan/endspan
Fig. 1a
CAT5 Cable to
Pace1PTM
OUT
Ports
1 4
IN
Pace16PRM
(front)
Structured
Cable from
midspan/endspan
Fig. 2
out to Pace4/8/16PRM
Pace4/8/16PRM
OUT
Ports
5 8
IN
OUT
Ports
5 8
IN
N/A
CAT5 or higher
Pace8PRM
Pace16PRM
OUT
Ports
9 12
IN
Pace1PTM
Yellow LED
indicates
PoE received
from Pace4/8/16PRM
OUT
Ports
13 16
IN
Yellow LED
indicates
PoE transmitted
to Camera/Device
Structured
Cable from
Camera/Device
- 3 -