Interfaces And Signaling Contact Of The Switches; Ethernet Interfaces - Electrical Ports; 10Base-T / 100Base-Tx - Siemens SCALANCE X320-3LD FE Operating Instructions Manual

SCP
STP
4.3

Interfaces and signaling contact of the switches

4.3.1

Ethernet interfaces - electrical ports

4.3.1.1

10Base-T / 100Base-TX

Transmission rate
The transmission rate of the electrical ports is 10 Mbps or as Fast Ethernet ports 100 Mbps.
Transmission mode
The transmission mode for 10Base-T / 100Base-TX is specified in the IEEE 802.3i / IEEE
802.3u standards of the Institute of Electrical and Electronic Engineers.
Autonegotiation (automatic detection of the best transmission modes) is default. The order in
which they are selected is:
● 100Base-TX full duplex
● 100Base-TX half duplex
● 10Base-T full duplex
● 10Base-T half duplex
Two communication modes are possible:
● Half duplex
Two-way alternate transmission mode - it is only possible to either send or receive over
the interfaces at any one time.
● Full duplex mode
Two-way simultaneous - both communication partners can send and receive at the same
time.
Connections to other switches can use half or full duplex; connections to hubs are possible
only in half duplex mode.
SCALANCE X-300
Operating Instructions, 05/2016, A5E01113043-20
4.3 Interfaces and signaling contact of the switches
SCP992-1
SCP992-1LD
STP991-1
STP991-1LD
Description of the device
850 nm
1310 nm
1310 nm
89