This equipment has been designed and manufactured to meet the highest international standards, but, like any electrical apparatus which is operated at mains voltage, care must be taken if you are to obtain the best results and safety is to be assured. This is particularly important with audio and TV equipment.
Page 3
PRESET DOOR SPEAKER INSIDE THE PRESET DOOR SKIP STAND BY CHANNEL SELECTOR PREVIOUS CALL SLEEP PICTURE/TIME POWER SWITCH PRESET AUTO MUTE TV/AV CHANNEL SELECTOR VOLUME CONTROL TIME PICTURE TIMER AUDIO IN VIDEO IN ANTENNA...
INSTALLING BATTERIES: 1. Remove the battery cover of Remote Control Unit. 2. Insert two "AA" 1.5V batteries making sure the polarity (+ or -) of the batteries matches the polarity marks inside the unit. 3. Close the battery cover. * When the Remote Control Unit is not used for a long time or the batteries are worn out, take out the batteries to prevent electrolyte leakage.
Page 5
Use the CHANNEL SELECTOR button on the Remote Control Unit to select channel 1) 0-9 channel 2) 10-19 channel 3) 20-29 channel 4) 30-39 channel 5) 40-49 channel 6) 50-59 channel...
NOTE: To select two digit channel, the second digit must be pressed within 2 seconds. * PREVIOUS BUTTON (REMOTE CONTROL UNIT) Pressing this button to select the channel that was tuned immediately before the one being watched. For example: If you are watching the program on channel 6, and the previous program you watched is on channel 15;...
4. Press PRESET ON/OFF button to exit preset mode. The searched program station has been memorised at the present channel position, 5. Repeat 1~ 4 steps to search another channel. NOTE : * If the same channel position is selected during repeat operation, the former memory will be erased.
PICTURE CONTROL (REMOTE CONTROL UNIT) Press the PICTURE CONTROL button on the Remote Control Unit. The FUNCTION to be adjusted is selected in sequence as shown in the following chart at every press of the button. Adjust the button to obtain satisfactory picture. ON SCREEN DISPLAY CAPTION...
Page 9
SLEEP BUTTON (REMOTE CONTROL UNIT) Using SLEEP button allows you to have the appliance automatically turned off a predetermined time, and set the appliance to stand by mode. SLEEP After the SLEEP function is set, the remaining time will be automatically displayed for 4 seconds every ten minutes.
Page 10
ON TIME OPERATION: 1. Set the CLOCK in operation mode. 2. Press the TIMER button until "ON TIME" displays on the screen. 3. Press the button to select the exact hour when you want to turn on the appliance. Press the button to select the exact minute when you want to turn on the appliance.
TROUBLE SHOOTING GUIDE Many apparent malfunctions may be caused by slight misadjustment of regular controls or some other equally similar simple causes. If any problem arises in the operation of your set, first check through this list of symptoms and correction. Should the problem be unsettled, unplug the set and contact your dealer.