Table of Contents
Advertisement
Attention! If the appliance is going
to be recessed (class 2 subclass 1),
connect it to the gas supply source
using only flexible stainless steel,
seamless pipes in accordance with
the standard.
Attention! If the appliance is
going to be installed free-standing
(class 1) and if you use the flexible
rubber hose, it is necessary to
follow the instructions and the
figure given below:
Attention! On its route, the hose
must not touch any parts where
the over temperature is than 95°C.
Attention! The hose must not be
subject to any kind of torsional
stress or tractive force, there must
be no pinched parts or really
sharp bends.
Attention! It must not touch
anything that can cut, that has
sharp corners, etc.
Attention! The whole length of
the hose must be easy to inspect
in order to keep a check on its
condition.
Attention! It must be replaced
within the date printed on it.
fig.6
20 mm +/- 3
Wall
chain tilt
5.3 Securing the cooker to wall
Note:- The installation of the chain
provided is for safety reasons, it must
be installed as indicated below.
To prevent the cooker tipping forwards
in the event of children standing on the
oven door or where users put extre-
me weight on the door when in open
position, two chains MUST BE fixed to
the back of the oven which should at all
times be secured to the threaded pins .
The threaded pins should be secured to
the wall at the back of the cooker.
Assembly instructions (fig.6)
• Secure threaded pins into wall imme-
diately behind and to the left-hand side
about 770 mm from the floor.
Finished fixing the chains must be
stretched
Position of threaded pin
Threaded pin
ENGLISH
19
Masonary wall
Hide quick links:
Advertisement
Table of Contents
