Download  Print this page

Husqvarna LTH1797 Owner's Manual page 20

Hide thumbs

Advertisement

Table of Contents
SERVICE AND ADJUSTMENTS
BELT KEEPER
MANDREL
PULLEY
IDLER
PULLEYS
MANDREL
PULLEY
TO CHECK BRAKE
If tractor requires more than five (5) feet to stop at highest
speed in high est gear on a level, dry concrete or paved
surface, then brake must be serviced.
You may also check brake by:
1. Park tractor on a level, dry concrete or paved surface,
depress brake pedal all the way down and engage
parking brake.
2. Disengage transmission by placing freewheel control
in "transmission disengaged" position. Pull freewheel
control out and into the slot and release so it is held in
the disengaged position.
The rear wheels must lock and skid when you try to manu-
ally push the tractor forward. If the rear wheels rotate,
then the brake needs to be serviced. Contact a qualified
service center.
TO REPLACE MOTION DRIVE BELT
(See Fig. 20)
Park the tractor on level surface. En gage parking brake.
For as sis tance, there is a belt installation guide decal on
bottom side of left footrest.
BELT REMOVAL -
Remove mower (See "TO RE MOVE MOWER" in this
section of manual).
NOTE: Observe entire motion drive belt and position of all
belt guides and keepers.
Remove belt from stationary idler and clutching idler.
Remove belt downward from around en gine pulley.
Pull belt slack toward rear of trac tor. Carefully remove
belt upwards from transmission input pulley and over
cooling fan blades.
Remove belt from center span keeper and pull belt
away from tractor.
WIRE BELT KEEPER
ENGINE
PULLEY
02844
FIG. 19
BELT INSTALLATION -
Carefully work new belt down around transmission
cooling fan and onto the input pulley.
Slide belt into the center span keeper.
Pull belt toward front of tractor and roll around the top
groove of engine pulley.
Install belt through stationary idler and clutch ing idler.
Make sure belt is in all pulley grooves and in side all
belt guides and keep ers.
Install mower (See "TO IN STALL MOWER" in this
sec tion of manual).
ENGINE
PULLEY
CLUTCH ING
IDLER
STA TION ARY
IDLER
TRANS MIS SION
INPUT PULLEY
TRANSAXLE
NEUTRAL ADJUSTMENT (See Fig. 21)
The motion control lever has been pre set at the factory and
adjustment should not be necessary.
Loosen adjustment bolt in front of the right rear wheel,
and lightly tighten.
Start engine and move motion control lever until tractor
does not move forward or backward.
Hold motion control lever in that position and turn engine
off.
While holding motion control lever in place, loosen the
adjustment bolt.
Move motion control lever to the neutral (N) (lock gate)
position.
Tighten adjustment bolt securely.
NOTE: If additional clearance is needed to get to ad just ment
bolt, move mower deck height to the lowest position.
After above adjustment is made, if the tractor still creeps
forward or backward while motion control lever is in neutral
position, follow these steps:
Loosen the adjustment bolt.
Move the motion control lever 1/4" to 1/2" in the direc-
tion it is trying to creep.
Tighten adjustment bolt securely.
Start engine and test.
If tractor still creeps, repeat above steps until satisfied.
20
CENTER SPAN
KEEPER
01510
FIG. 20
MOTION CONTROL LE VER

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Husqvarna LTH1797