Starting And Stopping - Husqvarna T536 LiXP Operator's Manual

Starting and stopping

WARNING! Note the following before
!
starting:
Never start a chain saw unless the bar,
chain and all covers are fitted correctly.
Otherwise the drive sprocket can come
loose and cause personal injuries.
Make sure you have a secure footing and
that the chain cannot touch anything.
If you need to start the chain saw in the
tree, see instructions under the heading
Starting the saw in the tree, under the
section Working techniques.
Keep people and animals well away from
the working area.
• Before inserting the battery into the machine, always
check to see that the power trigger actuates properly
and returnes to the "OFF" position when released. To
prevent the power trigger from being accidentally
pulled, a power trigger lockout is provided.
• Never start a chain saw unless the bar, chain and all
covers are fitted correctly. See instructions under the
heading Assembly.
• Observe your surroundings and make sure that there
is no risk of people or animals coming into contact with
the cutting equipment.
STARTING AND STOPPING
• Always hold the saw with both hands. The right hand
should be on the top handle, and the left hand on the
front handle. All people, whether right or left handed,
should use this grip. Use a firm grip with thumbs and
fingers encircling the chain saw handles.
Starting
• Insert the battery in the machine. The battery should
slide easily into the battery holder on the machine. If
the battery does not slide in easily, it is not being
inserted correctly.
• Press on the lower part of the battery and push it in as
far as it will go into the battery compartment. Make
sure the latches snap in place properly.
• Press and hold the start button (>1 sec.) until the
green LED is lit.
–
English 23