Working Techniques; General Working Instructions - Husqvarna 436LiB Operator's Manual

General working instructions

IMPORTANT! This section considers basic safety rules
when working with blowers. If you encounter a situation
where you are uncertain how to proceed you should ask
an expert. Contact your dealer or your service
workshop. Avoid all usage which you consider to be
beyond your capability. Working with blowers is
recommended for leaves or small branches only.
Show consideration to persons in your surroundings by
avoiding using the machine at unsuitable times, such as
late in the evening or early in the morning. Make sure local
regulations and ordinances are followed. Read through
and follow the simple directions so that you disturb your
surroundings as little as possible.
• Use the blower with the lowest possible throttle. It is
seldom necessary to use full throttle, and many work
procedures can be done at half throttle. A lower
throttle means less noise and less dust, and it is also
easier to keep control over the rubbish collected
together/moved.
• Use a rake or a brush to release rubbish stuck to the
ground.
• Hold the opening of the blower as close to the ground
as possible.
• Observe your surroundings. Direct the blower away
from people, animals, play areas, and cars etc.
• Minimise the blowing time by lightly wetting dusty
areas or using spray equipment.
• Be aware of the wind direction. Work with the wind to
make your work easier.
• If the machine starts vibrating abnormally, stop the
machine and remove the batteries.
• Using the blower to move large piles is time
consuming and creates unnecessary noise.
• Clean up afterwards. Make sure that you have not
blown rubbish into someone's garden.
• Walk with the machine, do not run.
Basic safety rules
• No unauthorised persons or animals may be present
in the working area, which is 15 metres.
16 – English

WORKING TECHNIQUES

• The powerful currents of air can move objects at such
a speed that they can bounce back and cause serious
eye injuries.
• Do not direct the air jet towards people or animals.
• Stop the engine before assembling or dismantling
accessories or other parts.
• Do not use the machine in bad weather, such as
dense fog, heavy rain, strong wind, intense cold, etc.
Working in bad weather is tiring and can lead to
dangerous conditions, e.g. slippery surfaces.
• Make sure you can move and stand safely. Check the
area around you for possible obstacles (roots, rocks,
branches, ditches, etc.) in case you have to move
suddenly. Take great care when working on sloping
ground.
• Do not overreach. Keep proper footing and balance at
all times.
• Keep all parts of your body away from hot surfaces.
• Never put the machine down with the product
activated unless you have it in clear sight.