5.
Disconnect the WLAN module antenna cables from the WLAN module (see
on page
6.
Remove the following components:
Hard drive (see
●
Keyboard (see
●
Top cover (see
●
USB board (see
●
Power connector cable (see
●
To remove the display assembly in its entirety:
1.
Disconnect the display panel cable (1) from the system board.
2.
Release the wireless antenna cables from the clips (2) built into the base enclosure.
NOTE:
CAUTION:
support the display assembly can result in damage to the display assembly and other
computer components.
3.
Remove the five Phillips PM2.5×6.0 screws (1) that secure the display assembly to the computer.
94
Chapter 4 Removal and replacement procedures
64).
Hard drive on page
Keyboard on page
Top cover on page
USB board on page
Models may have either one or two antennas installed.
Support the display assembly when removing the following screws. Failure to
70)
76)
79)
89)
Power connector cable on page
WLAN module
91)