Related Manuals for P3 International Mold Alert P0270
Summary of Contents for P3 International Mold Alert P0270
- Page 1 Mold Alert Operation Manual P0270...
- Page 2 introduction Congratulations on your purchase of the P0270 Mold Alert! Mold is as old as the Earth and it’s everywhere. Under the right set of conditions, it can actually start to grow inside your home. Some types of mold even contain mycotoxins (toxins produced by fungus-type organisms) which can be hazardous to your health.
-
Page 3: Start-Up
overview If the air is at a relative humidity of 40%, then the dew-point temperature is only 43°F. The walls and ceilings would therefore have to be significantly colder for the air to reach its dew-point and for water droplets to form. How to achieve the correct temperature and air humidity: Tips for active heating and ventilation: ●... -
Page 4: Reading The Display
set uP suggestions for Placement of the unit There is an opening on the back of the unit, which allows it to be easily hung from the wall. In addition, a base is provided for the unit to be placed on any surface in a standing position. Since the humidity level within rooms can vary greatly, the Mold Alert should be placed in an area most likely subject to mold growth. -
Page 5: Maintenance
Minimum/Maximum temperatures ● The highest temperature and humidity values since the last reset can be displayed by pressing the Min/Max button on the right side of the Mold Alert. ● The lowest temperature and humidity levels since the last reset, can be displayed by pressing the Min/Max button a second time. ● The current values can be shown again by pressing the Min/Max button a third time. ● The reset key is located above the Min/Max button on the right side of the unit and is used to reset Min/Max values when they are displayed. if humidity levels are high ● To lower humidity, you can open windows or put a fan in the area to better ventilate it, which may prevent mold growth. ● If there is moisture or a water leak, mold growth may have occurred. -
Page 6: Specifications
sPecificAtions Model: Relative Humidity: Room Temperature: Alarm Trigger Point: Display: Batteries: Weight: Dimensions: (Specifications subject to change without notice) The Swiss precision hygroTECH sensor allows our Mold Alert to give accurate measurements when checking a room’s ambient condition. P0270 1% to 99% RH, accuracy ±5% 14°F to 140°F, accuracy ±1% 65% humidity triggers audio/visual alarm User selectable F° or C°, Min/Max values 2 x AA (not included) 4.8 oz. 3 3/4"H x 3 3/4"W x 2 1/2"D... -
Page 8: Limited Warranty
P3 internAtionAl corPorAtion liMited wArrAnty P3 INTERNATIONAL CORPORATION (“P3”) warrants to the original retail purchaser only, that its product is free from defects in material or workmanship under the condition of normal use and service for a period of six (6) months from the date of purchase. In...